Oriental motor BLH Series - Page 51

51
Settings of MEXE02
9.4.3 Changing the rotation direction when the FWD/REV signal
*
is turned ON

"Motor rotation direction" parameter
Even when a gearhead with a reduction ratio which rotation direction is opposite to the motor output shaft is used, the
rotation direction of the gearhead output shaft when the FWD/REV input
*
is turned ON can be set to the same as that
of the motor.
Rotation direction of the motor output shaft
⇒
p.35
Input signal
Rotation direction when the input signal is turned ON
"Motor rotation direction" parameter
+=CW +=CCW
FWD/REV
*
CW
CC
W
*
This is the signal when the 3-wire mode is selected. When the 2-wire mode mode is selected, it is the FWD input.
9.4.4 Changing the input mode of the operation signal to the 2-wire mode.

"Operation input mode selection" parameter
The input mode of the operation signal can be changed from the 3-wire mode to the 2-wire mode.
3-Wire mode
Motor movement
ST
ART/STOP input
OFF
ON
OFF
ON
OFF
ON
RUN/BRAKE input
FWD/REV input
Instantaneous
stop
Deceleration
stop
Instantaneous
stop
2-Wire mode
FWD input
OFF
ON
OFF
ON
OFF
ON
REV input
ST
OP-MODE input
Motor movement
Instantaneous
stop
Deceleration
stop
Deceleration
stop