Maintenance and inspection
−164−
9 Inspection, troubleshooting and remedial actions
1 Maintenance and inspection
1.1 Inspection
It is recommended that periodic inspections would be conducted for the items listed below after each operation of the
motor. If an abnormal condition is noted, discontinue any use and contact your nearest Oriental Motor sales oce.
Note
•
Conduct the insulation resistance measurement or dielectric strength test separately on the motor and the
driver. Conducting the insulation resistance measurement or dielectric strength test with the motor and
driver connected may result in damage to the product.
•
The driver uses semiconductor elements, so be extremely careful when handling them. Static electricity
may damage the driver.
•
Do not conduct the insulation resistance measurement or dielectric strength test on an encoder itself.
Doing so may damage the encoder.
Inspection item
•
Are the mounting screws of the motor/gearhead loose?
•
Are there any abnormal noises in the motor bearings (ball bearings)?
•
Are there any abnormal noises in the bearing (ball bearing) and gear meshing parts of the gearhead?
•
Is the motor/gearhead output shaft misaligned with the load shaft?
•
Are there any scratches, signs of stress or loose driver connections in the cable?
•
Are the openings in the driver blocked?
•
Are any of the mounting screws or main power input unit of the driver loose?
•
Are there any strange smells or appearances within the driver?
1.2 Warranty
Check on the Oriental Motor Website for the product warranty.
1.3 Disposal
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.
To Next Page
Loading...
Need help?
General
