Made in the U.S.A.
TROUBLESHOOTING
D A N G E R
C A U T I O N
C A U T I O N
Be extremely careful working
around unshielded sharp edges.
Injury may result from contact
with sharp edges.
153 - 045
TROUBLESHOOTING
AVOID CRUSHING.
Make sure all personnel are clear of the implement. Lower implement
to the ground, place tractor in park, turn off engine, and remove key.
USE BAR STANDS TO SUPPORT THE IMPLEMENT.
Park implement on a clean, dry,
and level surface. An uneven surface could cause implement to shift or fall, resulting in
injury or death, as well as implement damage. Securely support all implement components
that must be raised. Remove buildup of grease, oil, or debris prior to adjusting rolling basket
down pressure.
PROBLEM:
Row unit plugs with field residue between the depth band coulter assembly and trash
opener assembly.
SOLUTION OPTIONS:
1. Proper toolbar height and orientation setting should ensure maximum depth band
coulter cutting depth. Make sure the coulter is penetrating soil in order that the depth
band governs soil penetration
(pg. 5 - 1).
2. Wet or damp field conditions can adversely affect the performance of the
1tRIPr®
row
unit. Typically, wet or damp field conditions do not allow residue to pass through the
row unit as effectively as drier conditions.
3. Alter ground speed to change rate at which field residue passes through row unit tool-
ing. Slower ground speeds generally reduce plugging by allowing residue to smoothly
pass through row unit tooling.
4. Slightly raise trash opener assembly to reduce residue in contact with the trash opener
assembly
(pg. 5 - 4).
5. Remove and store trash opener assembly
(pg. 5 - 4).
6. Adjust trash opener width (pg. 5-5).
7. Adjust trash opener distance
fore and aft
(pg. 5-5).
6 - 2
To Next Page
Loading...
