Installation and Operation Manual of the EUROMATIK.net Page 21 (40)
Heater settings
Press the "Menu" button in the
control bar.
Press the "Heater settings" button.
Setting the water temperature
Set the water temperature as desired.
Finally, press the "OK" button to save the desired
temperature.
Switching the heater on / off
Choose the mode of operation, heater "OFF" or "AUTO“ (Automatic)
(picture on the left) for the different heating systems.
Functions that are displayed in grey are disabled because the
corresponding heating system is not configured.
Frost protection
Press the "Menu" button
in the control bar.
Press the "Heater
settings" button.
Press the "Frost" button.
If there is no air temperature sensor connected to the EUROMATIK,
these functions are disabled and greyed out.
Enabling / Disabling the frost protection
Select the operating mode “OFF” or “AUTO” for the frost protection
function.
Selecting the activation temperature
Select the outdoor air temperature for starting the
frost protection function.
Finally, press the "OK" button to save the setting.
To Next Page
Loading...