Installation and Operation Manual of the EUROMATIK.net Page 28 (40)
Selecting the language
For display on the touch panel different languages can be selected.
Acoustic alarm signal
The acoustic alarm signal can be enabled or disabled on this page.
The "Operational statistics" button takes you to a
display of the operating hours and event counters.
With the "factory settings" button, the factory default
settings of the operating parameters are restored.
This feature is only available in expert mode (see
below).
To perform this function, a security prompt must be
confirmed.
The connection with the –communication server
can be deactivated in this menu.
You can also determine, whether the device
automatically obtains its IP settings from the
network (DHCP).
On this page, the IP addresses of the device can be
set manually, if they are not to be automatically
obtained from the DHCP server.
On this page, the PIN numbers for users and
service technicians can be changed. If "0000" is set
as the PIN, no login with PIN entry is required.
Factory defaults of PIN numbers
User-PIN=1234, Service-PIN=5678
In this menu you can choose, which fault conditions
are signalized as acoustic alarm, by email, or by
means of the potential-free relay contact. There are
3 menu pages with possible alarm conditions.
To adjust the appropriate fault condition in the list is
touched with a finger. In the thereupon opening
window, the implementation of the alarm can be
To Next Page
Loading...