Installation and Operation Manual of the EUROMATIK.net Page 26 (40)
Draining the swimming pool
In order to drain the swimming pool, press the "pool draining" button in the
menu (Manual control) for at least 5 seconds.
The filter pump is switched off automatically, but it can be switched on
again manually. (Attention, be aware of the possibility of dry running of the
pump).
The 6-way valve moves to the "Drain" position. The floor drainage valve
opens.
Info page (system overview)
Press the "Menu" button in the control bar.
Press the "Infos / Alarms" button.
On the Info page of the operating state of the entire filter system with all
measured values and possible error messages is displayed graphically.
Error message "Pump locked"
It is possible that a fuse on the motherboard is defective.
Resetting error messages
By pressing the "RESET" icon, error messages, for example after
activation of the electronic motor protection, can be acknowledged to
restart normal operation of the system.
Operating protocol
Press the "Menu" button in the control bar.
Press the "Protocol of events" button.
In operation log all important events are listed on a weekly basis.
The buttons and are used for flipping pages within the weekly
protocol.
By pressing the keys and you can change the calendar week to be
displayed.
Temperature charts
Press the "Menu" button in the control bar.
Press the "Graph of measurements" button.
To Next Page
Loading...