Installation and Operation Manual of the EUROMATIK.net Page 7 (40)
Mains connections when using a Speck Badu 90 ECO-Motion pump
A Speck Badu 90 ECO-Motion pump can be controlled
directly by the EUROMATIK.net. The speed controller
is connected to the terminals 6, 9, 10 and NO.
Jumpers must be inserted between the terminals 5
and C and between 7 and 8.
A jumper must be inserted between the two "WSK"
terminals.
The power supply for the pump must be fed
independently from the mains supply and cannot be
provided by the EUROMATIK.net.
The operation manual of the pump must necessarily
be observed and followed!
In the Setup menu on the pump, the external control
must be enabled for "digital fixed speeds" with the signal type "continuous signal". The speeds required for
ECO mode, normal mode and backwash mode must be set for the speeds N1, N2 and N3.
Mains connections when using a Pentair IntelliFlo pump
An IntelliFlo pump can be controlled with the help of the
Pentair Intellicom controller by the EUROMATIK.net.
The power supply for the pump must be fed
independently from the mains supply and cannot be
provided by the EUROMATIK.net.
A jumper must be inserted between the two "WSK"
terminals.
The operation manual of the pump must necessarily be
observed and followed!
Mains connections when using a Pentair SuperFlo VS pump
A SuperFlo VS pump can be controlled
directly by the EUROMATIK.net. The
speed controller is connected to the
terminals 6, 9, 10 and NO.
Jumpers must be inserted between the
terminals 5 and C and between 7 and
8.
A jumper must be inserted between the
two "WSK" terminals.
The power supply for the pump must
be fed independently from the mains
supply and cannot be provided by the
EUROMATIK.net.
The operation manual of the pump
must necessarily be observed and
followed!
To Next Page
Loading...