Installation and Operation Manual of the EUROMATIK.net Page 6 (40)
Mains connection when using a 400 V 3-phase pump
Three-phase power supply is fed from the mains. The filter pump is connected to the
terminals U1, V1 and W1.
If the pump has a thermal motor protection switch it is connected to the WSK
terminals, otherwise a jumper must be connected to these terminals.
The filter pump is monitored by the electronic motor protection in the controller for
over-current and phase failure.
Mains connection when using a 230 V AC pump
Single-phase AC supply is fed to the terminals L1 and N. The filter pump is
connected to the terminals U1 and N.
If the pump has a thermal motor protection switch it is connected to the WSK
terminals, otherwise a jumper must be connected to these terminals.
The filter pump is monitored by the electronic motor protection in the controller
for over-current.
Mains connections when using a Speck ECO touch pro pump
A Speck ECO touch pump can be controlled directly
by the EUROMATIK.net. The speed controller is
connected to the terminals 6, 7, 9, C and NC.
Jumpers must be inserted between the terminals 5
and 10 and between 8 and NO.
A jumper must be inserted between the two "WSK"
terminals.
The power supply for the pump must be fed
independently from the mains supply and cannot be
provided by the EUROMATIK.net.
The operation manual of the pump must necessarily
be observed and followed!
Mains connections when using a Speck ECO-VS pump
A Speck ECO touch pump can be controlled directly by
the EUROMATIK.net. The speed controller is
connected to the terminals 6, 7, 9, C and NC. Jumpers
must be inserted between the terminals 5 and 10 and
between 8 and NO. A jumper must be inserted
between the two "WSK" terminals. The power supply
for the pump must be fed independently from the
mains supply and cannot be provided by the
EUROMATIK.net.
The operation manual of the pump must necessarily
be observed and followed!
In the Setup menu on the pump, the digital inputs must
be set to „dI“.
To Next Page
Loading...