Installation and Operation Manual of the EUROMATIK.net Page 29 (40)
selected.
Finally, press the "OK" button to save the setting.
With the key on the bottom right you can reset the
alarm settings to factory defaults.
If the touch screen responds incorrectly to activities and calls unintended
functions, it can be recalibrated under this menu item. Here the step by
step instructions on the screen have to be followed.
Professional mode (Expert level)
The EUROMATIK.net provides a protection function against undesirable modification of important
operational parameters.
This protection function is enabled at the time of delivery. All functions shown in grey colour on the display
are then blocked.
Protective function ON (no icon) Protective function OFF
To switch off the protective function, touch the button
line with your finger and move it from the right to the left
over this line.
(Observe the symbol at the top left in the symbol line)
To switch on the protective function, touch the button line with your finger and move it from the right to the
left over this line. (Observe the symbol at the top left in the symbol line).
One hour after the previous operation of a button, the protective function is switched on again automatically.
Configuration of the controller
During the installation the controller must be configured for each pool to ensure proper function. To protect
the configuration from inadvertent adjustment, these settings can be operated only in Expert Mode.
Press the "Menu" button in
the control bar.
Press the "Service
functions" button.
Press the "Next page"
button.
Press the "Configuration
of hardware" button.
To Next Page
Loading...