Installation and Operation Manual of the EUROMATIK.net Page 25 (40)
Alternatively it is possible to program only a stop
time to generally turn off the output at a certain
time.
Temperature setpoint for spa
If the attractions output is configured for swimming
pool / whirlpool switch, the water temperature for
whirlpool operation can be selected here.
Finally, press the "OK" button to save the setting.
Manual control (manual operation)
Press the "Menu" button in the control bar.
Press the "Manual control" button.
Operating the swimming pool cover
Before operating these switches the swimming pool must be
inspected visually. Only if it has been ensured that there is nobody in
the swimming pool and that no hazardous situation can arise by
moving the swimming pool cover, should the swimming pool cover
be moved.
Starting the filter pump manually
In order to switch the filter pump on beyond the filter operating times that
have been programmed, press the "Filter pump" (Manual control) switch in
the menu.
In this mode, speed-controlled pumps are switched automatically between
filter speed and eco speed.
Starting the backwashing operation manually
In order to initiate the back-flushing operation manually, independent of
the programmed times, you need to press the "Filter backwash" button.
In this mode, speed-controlled pumps are automatically switched to
backwash speed.
To Next Page
Loading...