Installation and Operation Manual of the EUROMATIK.net Page 24 (40)
The drop in the water temperature can be
programmed by pressing the "Set temperature
reduction" button.
Finally, press the "OK" button to save the setting.
Eco mode and speed-controlled filter pump
When using a pump with speed control, the speed for the eco mode must be set in such a manner that the
flow rate is adequate for any dosing system that is connected.
Settings for the attraction output
Press the "Menu" button in the
control bar.
Press the "attraction settings"
button.
For the attraction output a runtime limitation can be
set to switch the output off after a period of time, if it
had been switched on manually. If the limit is set to
0, the output will not be switched off automatically.
Finally, press the "OK" button to save the setting.
Selecting / deselecting timer control
If the attraction is to be controlled by the integrated timer, the function “use
timer” has to be set to “yes”.
Setting / deleting switching times for the attraction
The attraction output can be controlled by an
integrated timer on a weekly basis.
Up to 10 operating periods can be programmed by
pressing the appropriate field in the schedule.
DL means daily. => The operations are carried out
each day at the specified times.
Finally, press the "OK" button to save the setting.
The switching operation time can be deleted by
pressing the garbage box icon. (Picture on the
right).
To Next Page
Loading...