Table of Contents
1.General Safety Requirement ........................................................ 1
2.Safety Terms and Symbols ........................................................... 2
3.General Inspection ........................................................................ 3
4.Quick Start ..................................................................................... 4
Front Panel Overview ............................................................................................... 4
Rear Panel Overview ............................................................................................... 5
Power On ................................................................................................................. 6
User Interface........................................................................................................... 6
5.Panel Operation ............................................................................ 7
Channel Setting ........................................................................................................ 7
Select the channel for configuration ................................................................... 7
To Display/Edit Both Channels .......................................................................... 7
Turn on/off channel output ................................................................................. 8
Waveform Setting ..................................................................................................... 8
Output Sine Wave ............................................................................................. 8
Set the frequency/period ............................................................................ 9
Set the amplitude ..................................................................................... 10
Set the offset ............................................................................................ 10
Set the high level ...................................................................................... 10
Set the low level ....................................................................................... 10
Set the Phase........................................................................................... 10
Output Square Wave ....................................................................................... 10
Output Ramp Wave ......................................................................................... 11
Set the symmetry ..................................................................................... 12
Output Pulse Wave.......................................................................................... 12
Set the pulse width/duty cycle .................................................................. 13
Set the rising/falling time .......................................................................... 16
Output Noise Wave ......................................................................................... 16
Output Arbitrary Wave ..................................................................................... 16
Select build-in wave (including DC) .......................................................... 17
Store ........................................................................................................ 22
Generate Sweep (Sweep) ...................................................................................... 24
Generate Burst (Burst) ........................................................................................... 25
Set N-Cycle Burst ............................................................................................ 26
Set Gated Burst ............................................................................................... 27
Output the Modulated Waves ................................................................................. 28
AM (Amplitude Modulation) ............................................................................. 29
To Next Page
Loading...
