EasyManuals Logo

Owon DGE3000 Series User Manual

Owon DGE3000 Series
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
5.Panel Operation
52
Sweep
Factory Setting
Sweep Time
1 s
Sweep Type
Linear
Start Frequency
100. Hz
Stop Frequency
1 kHz
Center Frequency
550 Hz
Frequency Span
900 Hz
Trigger Source
Internal
Burst
Factory Setting
Burst Period
1 s
Burst Mode
N_Cycle
Number of Cycles
1
Trigger Source
Internal
Slope
Positive
Counter
Factory Setting
High Frequency Reject
On
Utility
Factory Setting
Backlight
50%
Screen Saver
On
Screen Saver Time
30 Minute
Thousand Separator
Space
CH1 load
High Z
CH2 load
50 ohm
synchronization
Off
USB device
PC
Language
Factory Delivery Setting
Beeper
On
Firmware Update
Use the rear-panel USB port to update your instrument firmware using a
USB memory device.
Caution: Updating your instrument firmware is a sensitive operation, to
prevent damage to the instrument, do not power off the instrument or
remove the USB memory device during the update process.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Owon DGE3000 Series and is the answer not in the manual?

Owon DGE3000 Series Specifications

General IconGeneral
BrandOwon
ModelDGE3000 Series
CategoryPortable Generator
LanguageEnglish

Related product manuals