1. Turn on CH1 and CH2 channels.
2. Push the Save button.
3. Saving: Select Type in the bottom menu, select Wave in the left menu.
4. Select Storage in the bottom menu, select External in the right menu.
5. Select Type in the bottom menu, select BIN in the right menu as the
storage format.
6. Select Source in the bottom menu, check CH1, CH2 in the right menu for
Source.
7. Select Save in the bottom menu, an input keyboard used to edit the file
name will pop up. The default name is current system date and time.
Select the key in the keyboard to confirm.
8. Recalling: The BIN waveform file could be open by waveform analysis
software (on the supplied CD).
Tip:
Whatever the Type of save menu is set, you can save the waveform by just
pressing the Copy panel button in any user interface. If the Storage of the
save menu is set as "External", you should install the USB disk. Please refer
to the contents below to install the USB disk and name the file to be saved.
Save the current screen image:
The screen image can only be stored in USB disk, so you should connect a
USB disk with the instrument.
1. Install the USB disk: Insert the USB disk into the "USB Host port" of
"Figure 3-1 Front panel". If an icon appears on the top right of the
screen, the USB disk is installed successfully. If the USB disk cannot be
recognized, format the USB disk according to the methods in "USB disk
Requirements" on P68.
2. After the USB disk is installed, push the Save panel button, the save menu
is displayed at the bottom of the screen.
3. Select Type in the bottom menu, select Image in the left menu.
4. Select Save in the bottom menu, an input keyboard used to edit the file
name will pop up. The default name is current system date and time.
Select the key in the keyboard to confirm.
USB disk Requirements
The supported format of the USB disk: FAT32 file system, the allocation unit
To Next Page
Loading...
