CV GATE configuration
Shift + LFO opens the CV Gate grid layout.
This mode is shared by all Sequencers to avoid overlapping routings.
There’re 8 cvs and 8 gates that can be fully configurable in real time with playback on, this means you
can use this layout as an innovative tool for performance. You can turn on/off outputs, change voice
or Sequencer, modulation source or clock division with the press of a button.
The diagram below explains how the layout it’s distributed:
WORKFLOW
1- Sequencer selection:
The first 4 top rows select which Sequencer is providing the source, 1 to 4. Pressing again on the
active pad will turn off the corresponding output.
Tip: you can use this layout to create transitions in your performances adding and removing voices
and rhythms. Pressing on a highlighted sequencer turns it OFF.
2- Control signal selection:
Once you have selected the sequencer that will be sending information through this CV or Gate, you
need to choose which type of control signal this CV or Gate will output.
There are the following available options:
To Next Page
Loading...