PATTERN TEMPLATES
The templates folder can be found right after the 15th project in the projects folder.
Any of the 4 loaded patterns can be stored as a template. On the other hand you can recall a
template at any time and the template will be loaded in the selected sequencer.
The pattern template is a copy of the saved pattern. You can set up the pattern for a specific setup or
instrument (MIDI Channel, MIDI CCs, Scale, etc. ) and you can use it later as many times as you need.
Pattern templates can be renamed. To do so, tap save, navigate to the Templates folder with the first
encoder, select the template using the 2nd encoder and press “Rename template ”.
QUICK PROJECT SAVE
To QUICK save everything, press SHIFT and Save . This will save the project settings and the
current loaded patterns.
AUTOSAVE
If Autosave is enabled, the loaded project information and the loaded patterns will be saved when
switching the OXI One off.
· COPY AND PASTE
In OXI One there are several copy/paste actions available:
· Copy or paste a Sequencer by holding Copy or Paste and Sequencer buttons (1-4), corresponding
to the Sequencer that you want to copy or paste. For Multitrack mode, the active track will be copied
or pasted, unless pressing its sequencer button, then it copies all tracks.
· Copy/paste a Mono sequencer into Multitrack tracks. Copy the mono sequencer first and then press
Paste and tap the first pad of the destination track (1-8). This is very useful to use Mono mode power
to compose and Multitrack as a storage to free up a Sequencer slot.
· Copy/paste one Multitrack track into another. Press Copy and tap the first pad of the source track,
then press Paste and tap the first pad of the destination track.
· Pasting from a Poly sequencer will overwrite the Sequencer mode.
· Pasting from a Chord sequencer will overwrite the sequencer mode except pasting in
Poly, which you can use to fine tune your chord sequences by note.
To Next Page
Loading...