· CLEAR
Shift + Paste activates Clear.
In the sequencer view, press SHIFT + Clear to erase all the note events of the sequencer or
selected track in Multitrack mode.
Press SHIFT and long press Clear to Full Clear the sequencer. Steps information, time division,
pattern length, note offset, randomization settings, etc. will be set to default values but setup settings
like MIDI channel and MOD destinations won’t be affected for convenience in most cases. Although,
you can fully erase these remaining settings using the Save layout.
You can use this function to clear the loaded song/arrangement in the Arranger layout and you can
clear the MOD lanes’ values when the MOD screen is open.
· UNDO AND REDO
Undo has the last 10 states stored, press it repeatedly to undo unwanted takes. Press Shift + Redo
repeatedly to redo.
· Step toggling creates a new undo step. new
· Entering and removing TIED notes add a new undo step. new
· A new undo state is created when using the Random Generator, Expand, Condense, Clear,
Duplicate, Copy, Paste, Start and finish Recording and Loading a different pattern to avoid data loss.
The new undo step is indicated by a quick blink of the button LED.
· INIT, END and LOOP
Change the initial and final step of the active Sequencer or per track in Multitrack.
You can hold Init or End and:
- either press any step on the grid,
- turn encoder 2 and 3,
- or press the pages buttons , , and .
Double click on the page buttons to select pages 80, 96, 114 and 128.
When any of the or buttons are held, the grid LEDs will indicate the start and end points
of the pattern in purple color.
To Next Page
Loading...