Shift + or doubles or halves the time division of the
selected Sequencer respectively.
To activate LOOP , hold both Init and End buttons and then
press any two steps of two different columns, those will become
the looping points (or the same column and different rows to loop 1 single step). For Multitrack mode
do the same in two steps of the same track (row). It’ll loop until you press Init and End again. Loop
will still be on until it is manually disabled. When so, the sequence will continue to play in sync.
–––––––––––––––––––––
W ith a LOOP activated, hold the number of the active Sequencer and press a pad below or above the
notes played to transpose the LOOP without affecting the steps outside of it.
–––––––––––––––––––––
In Multitrack mode, you can change Init and End steps of all the tracks at once by holding its
Sequencer number button + Init or End and the desired step.
In order to improve the workflow, setting the pattern start step further than the current final one will
offset both positions in an amount equal to the pattern length.
Example: Start step is 1 and end step is 16 and you press Init + page 32, the new start and end
points will be 17 - 32 respectively.
You can also use Init or End buttons in conjunction with any track step in Matriceal mode to set the
start and end points of any of the parameter tracks.
· Y DIV - EXPAND
It activates the Division menu. From left to right:
· Grid Vertical Scroll
· Playback direction
· Random Time Division
· Time Division
A quick tap will open the menu, a long press will open it momentarily until button release.
The Piano Roll view on the grid is set to the octave selected by Oct and the root note being the lower
row. To move the view up or down to reach higher or lower octaves and further edit steps, use the
Vertical Scroll (first encoder). When you move vertically through the grid, you’ll see the rows
highlighted, those indicate the position of your root note.
Pressing Shift while doing so will jump in increments of octaves instead of scale intervals.
Vertical Scroll is deactivated in Multitrack, you can select the active track instead.
To Next Page
Loading...