LFOs
Another great way to create variation on your sequences is to automate parameters with the LFOs.
There are 2 LFOs per Sequencer and both can modulate one internal and one MIDI parameter.
LFO RANGE
The LFO output range depends on the chosen destination. It has been adjusted to get the optimal
control for each use case. When the LFO is applied to an internal parameter, the values are bipolar
(-128 to 127) while if the LFO is sent to a MIDI CC, the values are adjusted to the optimal MIDI range
which is 0 to 127.
CC Destinations
When the LFO is sent to a CC parameter and the amount is 100%, the CC range goes from 0 to 127.
Reducing the amount, for example to 50%, will set the range from 0 to 63. It is possible to apply an
offset so the CC parameter minimum value is shifted. If the offset is +64 and the amount is 50%, the
CC will go exactly from 64 to 127.
PITCH BEND
The maximum range is adjusted to -8192 to 8191 in this case.
INTERNAL Destinations
When the LFO is applied to an internal destination it will introduce positive and negative changes. It’s a
bipolar value controlled by the Amount and Offset settings in the LFO.
Take into account the LFO resulting value is not normalized between destinations. It depends on how
many values the parameter has. Check the Internal Destinations section for more information.
CV LFO Output
The maximum range of the CV LFO output is 0 to +5V. There won’t be negative voltages even if a
negative offset is applied. Values will still be clipped between 0 and +5V.
In order to get voltages down to -3V which is the minimum the hardware admits, you need to adjust
the offset of the CV output.
LFO SCREEN
The LFO screen consists of:
Waveform, there are many to choose from, even unusual shapes.
Rate can be clocked up to 2 bars moving the encoder to the left.
Moving to the right will get you to free running LFO. Synced modes only
work when the OXI One is running.
Amount, sets the modification range of both the internal and external
modulation. Alternatively you can press SHIFT + encoder turn to adjust
the external/MIDI amount separately.
Offset, adds offset to the LFO value. Useful for unipolar destinations like
CCs and AT messages or for certain internal destinations.
To Next Page
Loading...