FUNCTION BUTTONS
TIP: Jump to the Sequencer Mode section and skip the Function Buttons section if you want to start
working with Mono, Chord, Multitrack or Polyphonic sequences right away. There are links to
bookmarks to help you navigate when a Function Button is mentioned.
However, reading the function buttons section first helps to get familiar with the general workflow
through all the sequencers.
· TRANSPORT
The following behavior applies to Internal Synchronization:
Rec enables recording from the Keyboard view or from any MIDI input..
Stop halts and resets all the Sequencers to step 1.
Play/Pause/FILL works as expected by default, but you can change this in the Config menu to:
- Reset all the sequencers playhead to the start points
- Pause
- FILL modifier
- Do nothing
Recording: the sequencers will receive the incoming MIDI information depending on the
MIDI In channel filtering configuration option.
If MIDI In channel filtering is ON, every sequencer will listen to its own MIDI channel. If OFF, the
selected sequencer will listen to any channel.
MUTE OPTIONS new
In the config menu you can select the Mute behavior that works best for your workflow.
Toggle Instant
Mute + sequencer click: activates or deactivates the sequencer playback.
When the sequencer is inactive, transport in that sequencer is stopped. Activating the sequencer
starts transport according to the Punch-In quantization setting.
Toggle On Release
Hold Mute and click as many sequencer buttons as you want. The sequencers will be
enabled/disabled on release of the Mute button.
Mute Instant
Mute + sequencer click: mute / unmute instead of activating/deactivating the sequencer.
In a Muted sequencer the transport bar is still running but no notes or cv-gate information is
outputted.
To Next Page
Loading...