○ OFF ignores the input reset and deactivates the output reset signals. When OXI One’s sync is set
to Clk, it will start running as soon as it receives clock pulses.
○ PULSE RESET: Both input and outputs will behave as RESET signals.
■ Output: A short 4ms pulse is sent through the Reset out before the first clock out pulse when
OXI One starts or continues playing.
■ Input: When OXI One’s synchronization is set to Clk and a reset pulse is received in the Reset
Input, OXI One will reset, this means reset the sequencers playheads.
○ RUN-STOP. Other synths or drum machines expect a different kind of reset signal. The run-stop
or start-stop output is high when the OXI One is playing and low when stopped. On the other
hand, when Sync is set to Clk the OXI One will only play if the Reset input signal is high and stop
otherwise.
● Gate V Out. Configures the output voltage of all the gates to 5V or 10V.
● Remember params when On/Off individual outs. If Off, all the settings of a CV/Gate output are
reset, otherwise they are remembered when turning the output back on.
● CV & Gate voice allocation. Both options are described in the CV GATE section.
PERFORMANCE
● Taps count for tempo. Sets the number of taps that are taken into account for calculating the
new BPM value. Infinite means that the average calculated tempo is never reset thus offering a
smoother transition. On the contrary, a smaller value will offer more immediate tempo adjustments.
● Pause determines how the Play button behaves when the OXI One is playing.
○ OFF, pause is disabled. This means the Play button only has any effect when the OXI One is
stopped.
○ ON pause is enabled. While the OXI One is playing, tapping the Play button will pause.
○ RESET instead of pausing the playback, it will Reset the playback head of all the sequencers
according to their punch in settings.
○ FILL, play button acts as FILL modifier button. When it’s held, steps set to FILL will play and
steps set to NOT FILL won’t.
● Keyb Arp Velocity. If PER NOTE PLAYED, the keyboard arpeggiator will respect the velocity of the
notes at the time they were played. If GLOBAL, the keyboard arpeggiator will apply the current
keyboard velocity when playing the notes.
● Keyb Arp latch when hold is active. This selects how the arpeggiator will behave when new
notes are entered from the internal or an external keyboard and HOLD is active.
○ Latched (or sequencer mode) will keep adding new notes to the pattern until the note buffer is
full.
○ Normal (Non Latched) will reset the played pattern when a new set of notes is entered.
● Arp 8 Patt Reset. This setting affects the Arpeggiator when it is set to any of the ‘8 Patt’ modes. If
set to ‘Yes’, it resets the pattern to the beginning every time there’s a change in the set of
arpeggiated notes.
● Loop release sync. Changes the behavior of the LOOP function when it’s released, SYNC BAR:
the sequence will continue on the next bar; SYNC BEAT, the sequence will continue on the next
beat or step; NO SYNC, the sequence will continue exactly when it’s released.
● Auto Sync. Enables or disables Autosync.
● Keyboard Layout.The available Classic or Isomorphic layouts explained in the Keyboard section.
● Mute behavior.
○ Toggle Instant
To Next Page
Loading...