RESET
Reset the sequence after a selected number of bars (1 - 64). Useful in Multitrack to realign tracks or to
get back to sync the sequencer when time or division modulations are applied to it.
BANK
Sends a MIDI Bank Select message to the selected MIDI channel and Output destination on pattern
load or in the Arranger.
Note: This parameter is set per track in Multitrack Mode.
COLOR
Color of the sequencer notes on the grid, Piano Roll, Keyboard, Patterns and Arranger Lanes.
Note: some of the available colors may provide better visual feedback than others.
STEP PARAMETERS
In any mode and in general, there are global parameters and per step parameters. To modify the
global parameters, use the encoders, adjusting the Velocity, Octave, Gate and Mod; Swing, Scale
and Root with SHIFT + encoder.
The global parameters Velocity, Octave, Gate and Mod act as an offset of the step parameters when
the steps have different settings, showing instead the minimum and maximum step values. For
example, the velocity of your sequence ranges from 50 to 110 (MIDI values range from 0 to 127), then
moving the global velocity CW will give you +1 increments on all the steps (51-111, 52-112 …).
When the maximum or minimum value is met and passed, the extreme values will be limited and this
range will be reduced, from our example before that would be 100-127 with an increment of 50
points. Reducing the global value again will keep the new range, returning to the example that’d be
80-107 with a decrease of 20 points.
With this implementation you can perform over global parameters . By reaching extreme values, you
can quickly set the same value for all steps again.
This behavior happens also when the values are automated with randomization and LFOs, so it acts
as an extra offset/limiting control.
In Gate values, after the maximum value of 100 you have TIE, to set two steps as a tied notes.
After TIE there’s LEGato, in which the Note ON message of the next note is sent before the Note OFF
of the previous one to enable the legato behavior on the synth, for example for glides.
MODULATION PARAMETER
Every Sequencer has 4 Modulation Lanes except for Multitrack that has 8 (1 per track in 2 banks of 4),
to access them press the MOD button. These 4 modifiers can be configured in the CC Configuration
screen. Each Lane has a value per step that would be saved with each Pattern.
In this view, each encoder acts as a global control of each modulation lane.
The last Modulation Lane used before exiting MOD screen will be
set as the global Mod control of the 4th encoder. Mod Wheel is
the default Mod.
To Next Page
Loading...