ADDITIONAL STEP PARAMETERS
There are extra step parameters that can be accessed by holding SHIFT and pressing any
grid pad or toggling the Step-Chord button. This is an overview of these parameters, all the
information can be found in the Sequencer Modes section.
- Glide, it sets the time of the pitch to change continuously between two consecutive notes. At the
moment it only affects the CVs pitch output.
- Prob, and Logic conditions. Logic conditions appear if you turn the 2nd encoder CW.
- Retrigger (ratcheting), sets the times the note is triggered during the step duration, up to 5 times.
For better resolution change the Time Division of the Sequencer or Track.
- Timing Offset, sets the time deviation of the note from -45% to 45% of the current time division.
25% is a quarter deviation from the duration of the step.
±
SEQUENCER DATA
Each Sequencer (1 to 4) has its own global parameters that are configurable independently per
Sequencer:
· Sequencer view and steps pages
· MIDI channel configuration (up to 32 tracks on different channels, 32 channels available for
the USB output in two separate virtual ports and up to 48 MIDI channels using the OXI Split).
· Keyboard layout, designed for each mode
· Tracks, depending on mode
· 16 Pattern slot memory per Sequencer (64 slots per Project)
· Arranger lanes (4)
· Scale
· Arpeggiator (per track)
· Loop (per track)
· Swing
· Randomizer engine
· Initial and End steps (per track)
· Time Division signature (per track)
· MOD configuration (up to 8)
· LFOs
· ENCODERS
The encoders function as the interface to all parameter changes.
We will be referring from now on as “CW” to clockwise rotations and “CCW” to counter clockwise
rotations of the encoders.
In Sequencer view, the parameters each encoder modifies applies to the selected Sequencer (1-4):
· VELocity (secondary function: Tempo)
· OCTave (secondary function: Swing)
To Next Page
Loading...