Paccar DAF CF - 12.7 Axle load calibration

313
12
Air suspension
On semi-trailers with Axle Load Monitoring, all individual axle loads are shown.
On semi-trailers without Axle Load Monitoring but with EBS, only the overall axle load
of all axles is shown in the display.
On semi-trailers with neither EBS nor Axle Load Monitoring, only the axle load of the
truck is shown.
NOTE: A highlight on the axle and its load value show the selected axle or
indicates the axle's overload. See 'Axle overload warning'.
Rigid
When the 'Axle load' function is
selected in the menu, a number of axle
loads (C) are shown, depending on the
vehicle configuration. The value (D) that
is displayed in the vehicle indicates the
vehicle load.
It depends on the type of the vehicle
whether the axle load values are
shown. For instance, the axle load on a
leaf-sprung front axle is not shown. On
a full air-suspended truck, all axle loads
are always shown.
When a small arrow (B) is shown to the
right side of the display, the Menu
Control Switch can be used to retrieve
information on the trailer.
NOTE: The axle loads are
only shown when the vehicle
is at standstill.
Trailers
Select the small arrow (B) using the
MCS to open the screen with the
information on the trailer.
To display the axle load on a trailer, the
following conditions must be met:
– The trailer must have an EBS brake
system, or
– The trailer must have an air
suspension version that supports
Axle Load Monitoring.
D001737
Axle load
7.5 6.1 5.0 5.0
x 1000 kg
Total 45.7
Reset
+12.5
0
D001738
Axle load
6.39.56.3
x 1000 kg
Total 45.7
Reset
+15.7
0
DW63246305.book Page 313 Friday, March 22, 2019 4:54 PM