343
Emergency repairs
11. Place the bulb fitting in the reflector and turn it to the right until it stops and a click
is heard.
12. Place the service cap. Turn it to right until a click is heard.
13. Position the upper cover in the stepwell.
14. Install the attachment bolts.
Dipped beam
15. To replace the dipped beam bulb
pinch the bulb fitting and turn it to
the left (about 45°).
NOTE: Do not remove
both screws (1).
16. Now the bulb fitting with bulb can be
taken out of the reflector.
17. Pinch the bulb fitting and replace the
bulb.
NOTE: The bulb can
only be placed in the bulb
fitting in one position.
18. Place the bulb with the bulb fitting in the reflector and turn it to the right (about 45°).
NOTE: The bulb fitting can only be fitted in the reflector in one position
(2).
19. Place the service cap. Turn it to right until a click is heard.
20. Position the upper cover in the stepwell.
21. Install the attachment bolts.
Direction indicators
1. Remove the upper cover in the stepwell.
2. Rotate the bulb fitting (2) anti-clockwise.
3. Pull the bulb fitting out of the reflector.
4. Replace the bulb.
5. Push the bulb fitting into the reflector and rotate the bulb fitting clockwise to secure
it.
6. Install the upper cover in the stepwell.
7. Install the attachment bolts.
D005050
1
2
1
DW63246305.book Page 343 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
