5
ENGLISH
❖ Inserting the batteries in your remote control
Before you can use your remote control, you must insert the two supplied AA batteries as
follows:
1. Push the catch at the bottom of the remote control battery cover up, then lift off
the cover.
2. Insert the batteries as shown below. Be sure to match the + and – marks on the
batteries to their respective marks inside the battery compartment.
3. Replace the battery cover, by inserting the tab at the top of the cover first, then
pushing the cover into place.
8 Don’t leave flat batteries in your remote control.
4 Replace both batteries at the same time.
8 Do not dispose of used batteries with your domestic rubbish.
4 Used batteries should be recycled at the end of their useful life.
Also see “Environmental Issues” on page 4.
Your remote control
To Next Page
Loading...
