37
ENGLISH
❖ Setting up your remote control for your TV
You can set up your remote control to operate the basic features of your TV. This enables
you to control your TV and your box with just one remote control.
Code search
To program your remote control to operate your television, you must first use the remote
control to find the four-digit code that corresponds to your television brand. During this
code search you will run through every available code in the remote control’s library.
To search for your television code:
1. Make sure that your television is switched on.
2. Press the TV button on your remote control and release it.
3. Press and hold down SETUP, until the red LED under the TV button blinks
twice.
4. Use the number buttons to enter 9 9 1. The red LED under the TV button
blinks twice.
5. Aim the remote control at your television and press S.
6. Aim the remote control at your television and press CH + repeatedly, until
your television turns off (each time you press CH + the remote control sends a
POWER (TV off) signal using the next TV code contained in the remote control’s
library).
You may have to press CH + many times (up to 150 times). The code search can
take up to 15 minutes. If you skip a code, you can search through the previous
code(s) by pressing CH -.
Remember to keep pointing the remote control at your television during the
code search.
7. As soon as the television switches off, press SETUP to store this code. The red
LED under the TV button blinks twice.
8. Once it is set up, you can switch the remote control to operate your TV by first
pressing the TV button. To switch back to operating your box, press the VIASAT
button.
Code blink out
Once you have found the correct code, you can use your remote control to perform a
‘code blink out’ to determine what this code is.
1. Press the TV button on your remote control and release it.
2. Press and hold down SETUP, until the red LED under the TV button blinks
twice.
3. Use the number buttons to enter 9 9 0. The red LED under the TV button
blinks twice.
4. Press 1 and count the LED blinks.
5. Press 2 and count the LED blinks.
6. Press 3 and count the LED blinks.
Settings
To Next Page
Loading...
