38 Using your ViasatHD box
7. Press 4 and count the LED blinks. Now you have found the 4-digit code.
If, during step 4, 5, 6 or 7, the LED does not blink at all, the code digit is 0.
8. For future reference, write down the code in the space provided in the remote
control battery compartment.
Using the TV code table
If, after performing a code search, your remote control still does not operate your
television, you may be using the wrong code. Try repeating the search again to locate the
correct code. If this fails, you can use the TV code table available for download from the
Viasat web site.
1. Download the TV code table from the Viasat web site (www.viasat.se), find the
brand of your television in the TV code table and select the first 4 digit code in
the list.
2. Make sure your television is fully on (not in standby), and then press the TV
button on your remote control and release it.
3. Press and hold down SETUP, until the red LED under the TV button blinks
twice.
4. Use the number buttons to enter the 4-digit code for your television (the TV
button will blink twice after you have entered the fourth digit).
5. Press S to see if you are able to switch off your television.
If your television does not respond, repeat steps 1 to 5 with each code listed for
your brand. If none of the codes operate your television, or if your brand is not
listed, retry the code search described on page 37.
6. Switch your television back on by pressing a number button (or CH +) and
check if all the functions are working correctly.
7. For future reference, write down the code in the space provided in the remote
control battery compartment.
Resetting your remote control
To clear all the settings you have made to your remote control and apply the factory
defaults:
1. Press and hold down SETUP, until the red LED under the TV button blinks
twice.
2. Use the number buttons to enter 9 8 1. The red LED under the TV button
blinks twice.
The factory default values are applied to your remote control.
Settings
To Next Page
Loading...
