11
ENGLISH
*DiSEqC™ is a trademark of Eutelsat.
Installation
Satellite dish
You need a correctly-installed satellite dish, pointing at the correct satellite(s).
◆ If you have a satellite dish but it is not pointing at the correct satellite(s), you
need to make adjustments. Please see the information supplied with your dish/
LNB for details on how to do this, or seek professional advice.
◆ If you do not have a satellite dish installed, please ask your dealer to recommend
a local dish-installation engineer.
Single LNB (SatCR or Universal)
If you have one LNB only, to ensure the simplest installation method, and for the best
Viasat channel line-up, you should use the ‘Sirius’ satellite, at 5° East. However, if you prefer,
you can set up your system for any one of the four satellites listed in the LNB positions
table below.
Multiple LNBs (Universal only)
If you are using a DiSEqC™ unit* with 2 LNBs/satellite dishes, to ensure a simpler
installation, and for the best Viasat channel line-up, you should connect up the LNBs to the
DiSEqC™ ports as shown in the LNB positions table below.
You must then connect your DiSEqC™ unit to the satellite input on your set-top box (see
also pages 12 and 13).
LNB positions table
Satellite Position Recommended DiSEqC™ port (for
multiple LNB set-ups)
Thor 1° West 1
Sirius 5° East 2
If you change your satellite dish installation, you may need to change your settings so that
your box can tune to all the satellites available - See “Changing installation settings” on
page 33.
To Next Page
Loading...
