Palm Tungsten T3 Handbook

Using Graffiti
®
2 writing
23
The input area has two different Graffiti 2 screens that you can access from the
status bar.
The two Graffiti 2 screens have designated areas that recognize certain characters.
If those characters are written in the wrong area, they are not recognized correctly
and an incorrect character is written. For a list of characters and the designated
Graffiti 2 area where they can be written, see “Graffiti 2 character set” later in this
chapter.
Using Full-screen Writing
When Full-screen Writing is turned on and is active, you can write outside the
Graffiti 2 input area. When Full-screen Writing is turned off or is inactive, you must
write character strokes in the Graffiti 2 input area for your handheld to recognize
them.
You can write letters or characters in the following areas:
■ Left side of the screen: letters or characters that are assigned to the abc or ABC
input areas
■ Right side of the screen: numbers or characters that are assigned to the 123 input
area
■ Middle of the screen straddling the imaginary dividing line between the left and
right sides:
capital or uppercase letters
NOTE
For a brief period of time after writing a character, a quick tap on the screen is
interpreted as a period character. This makes is easier to tap buttons and place the
cursor without having the action interpreted as a period character.
Tap and hold.
Then select Graffiti 2
input area icon from
menu.
Uppercase letters
Lowercase letters
Numerals
Uppercase letters
straddling line
Lowercase letters
Numerals

Palm Tungsten T3 Specifications

General

Brand	Palm
Model	Tungsten T3
Category	Handhelds
Language	English