Panasonic AG-CPD20P - System and Update Error Codes; Card and File Operation Errors

112
113
Error Message
(continued)
No. Message Measure
E00463
Invalid update file was found. The update le on the SDHC Memory Card or USB memory device is
corrupted.
• Check whether the update le for the recorder has been correctly copied
to the SDHC Memory Card or USB memory device.
• Reformat the SDHC Memory Card or USB memory device before use.
• Use another USB memory device.
E00464
E00465
E00466
Unexpected update failure was
found.
Some other update error occurred.
• Check whether the update le for the recorder has been correctly copied
to the SDHC Memory Card or USB memory device.
• Reformat the SDHC Memory Card or USB memory device before use.
• Use another USB memory device.
E00467
E00468
Update file was not found. No update le could be found on the SDHC Memory Card or USB memory
device.
• Check whether the update le for the recorder has been correctly copied
to the SDHC Memory Card or USB memory device.
• Reformat the SDHC Memory Card or USB memory device before use.
• Use another USB memory device.
E00469
This media cannot be used for
update.
The used SDHC Memory Card or USB memory device cannot be used for
updating.
• An SDHC Memory Card with a \DATA folder cannot be used for updating.
• A USB memory device containing a folder other than the \WIDKEY folder
cannot be used for updating.
E00470
Update file cannot be read. An update le load error occurred.
• Check whether the update le for the recorder has been correctly copied
to the SDHC Memory Card or USB memory device.
• Reformat the SDHC Memory Card or USB memory device before use.
• Use another USB memory device.
E00499
Unexpected update failure was
found.
Some other update error occurred.
• Check whether the update le for the recorder has been correctly copied
to the SDHC Memory Card or USB memory device.
• Reformat the SDHC Memory Card or USB memory device before use.
• Use another USB memory device.
E00602
AG-RCP30 needs to be updated!
Will start updating soon.
A connected AG-RCP30 was found to need an update.
The recorder reboots automatically to start an update.
E00603
Unsupported Control Panel!
Replace Control Panel.
A Remote Control Panel not supported by this recorder was detected.
Disconnect the Remote Control Panel.
E00604
Will power off after uploading.
Turn ACC ON to cancel power off.
The vehicle engine switch is set to LOCK (OFF) when “PowerOff Time” on
page 81 is set to “AUTO”. The system awaits that the connection with the
Front-End or Back-End application is released, or uploading, streaming,
administrator setup, or upgrading on the Back-End application is nished.
To continue using the recorder without turning it off, set the engine switch to
ON.
E02431
DSP error.
This system is rebooting.
Wait until the error message is cleared. Contact your supplier if the message
does not clear after about a minute.
E02432
E02440
System error.
Couldn’t format cards.
Insert another SDHC Memory Card.
E02441
Couldn’t format cards.
E02442
Write Protect cards found.
Couldn’t format.
Disable SDHC Memory Card write-protection.
E02444
No SDHC Cards found.
Couldn’t format.
Insert an SDHC Memory Card.
E02460
System error.
Couldn’t delete files.
Contact your supplier.