Panasonic AG-CPD20P - Recorder Setup Options; Officer Configurable Settings

18
19
Setup
Factory default values are shown below.
Items officers can set
Setting Item Factory Default Value Description
1 Camera1 Color camera connected the [CAMERA 1] connector setting
AE[–2 -- +2]
0 Color camera video brightness setting totally
Setting : -2, -1, 0, +1, +2
LPR Mode PATROL LPR mode setting
Setting : PATROL (normal mode), LPR (License Plate Recognition
mode)
Patrol Shutter Speed AUTO Shutter speed setting with [LPR Mode] set to “PATROL”
Setting : AUTO, 1/100, 1/500, 1/1000
Patrol Zoom ×1.0 Zoom ratio setting with [LPR Mode] set to “PATROL”
Setting : ×1.0 - ×22.0
LPR Shutter Speed 1/1000 Shutter speed setting with [LPR Mode] set to “LPR”
Setting : AUTO, 1/500, 1/1000
LPR Zoom ×1.0 Zoom ratio setting with [LPR Mode] set to “LPR”
Setting : ×1.0 - ×22.0
2 Audio/Video Audio and video setting
Image Enhance OFF The brightness of a dark video image on the main screen adjustment
Setting: OFF (no enhancing)
LOW (enhancing slightly)
HIGH (enhancing strongly)
VIDEO OUT1 VIDEO OUT2 Output to [VIDEO OUT1] connector
Setting: CAM1 (Camera 1)
*
1
CAM3 (Camera 3)
*
1
VIDEO OUT2 (the same signal as that output from the
[VIDEO OUT2] connector)
3 Setup/Info Setup/Information
Ofcer Ofcer settings
Ofcer 1 ID ---- Ofcer 1 ID
Ofcer 1 Name ---- Ofcer 1 name
Ofcer 2 ID ---- Ofcer 2 ID
Ofcer 2 Name ---- Ofcer 2 name
Source
*
2
---- Source
Area
*
2
---- Area
Shift
*
2
---- Shift
Work Time ---- Work Time
Overlay OSD OFF Overlay OSD setting
Setting : OFF, AUTO, SIMPLE, DETAILS,
Camera1 Rec LED ON Color camera [REC] lamp setting
Setting : ON, OFF
Target Speed OFF Target vehicle speed setting
Setting: OFF, 1, 2, …, 200
*
3
*
1 CAM1 and CAM3 may not be displayed, depending on
the settings made on the Video Allocation screen in
Administrator setup.
*
2 If the Front-End application is connected, the names,
Source, Area, and Shift, may be different from the
corresponding field names of the Front-End application.
The field name of the Front-End application can be
changed using the Back-End application.
*
3 This may not be selected, depending on the setting made
on the Trigger screen in Administrator setup.