Status Display
Playback with the remote control panel is not available
at present. Upgrading is scheduled for the future.
For playback, it is recommended to use the Front-End
application or Back-End Client application.
The Status Display shows messages about the operating status of the SDHC Memory Card and the recorder. Take action as
appropriate for each status.
Status Display Measure
CARD FULL The following conditions may have occurred.
• There is no space left on the SDHC Memory Card.
• Files contained in one of the SDHC Memory Cards inserted in the SDHC Memory Card slots 1, 2,
3, and 4 exceed 5,000 les.
Replace the SDHC Memory Card with an SDHC Memory Card with free capacity, or free up
space in the SDHC Memory Card for new data.
CARD PROTECT The write-protect switch of the SDHC Memory Card is set to “LOCK”. Move the switch to enable
writing.
VUP CARD Writing is not possible on an SDHC Memory Card intended for version upgrade. Replace the card
with one that is not intended for version upgrade.
UNFORMATTED The SDHC Memory Card is not formatted. Replace it with a formatted card.
NO CARD No SDHC Memory Card is inserted. Insert an SDHC Memory Card.
READ ERROR An error occurred while reading. File playback is not possible, or the associated meta information
cannot be displayed correctly.
UNSUPPORTED Archive screen: The le is unsupported. Playback is not available.
Live screen: The memory card is unsupported. For the memory card supported, refer to “Usable
memory cards” in Operating Instructions Section 1: Before Use.
PLAY ERROR A decoder malfunction occurred. Playback is not available. Reboot the recorder.
To Next Page
Loading...
