Panasonic AG-CPD20P - Camera 1 Configuration

26
27
Setup
(continued)
Setting Item Factory Default Value Description
7
Camera1 Color Camera connected to the [CAMERA 1] connector setting
Zoom Limit ×220 Maximum zoom magnication
Setting : ×22, ×220
AGC Level HIGH Color Camera automatic gain control setting
Setting : HIGH, OFF, LOW, MID
Init Backlight OFF Initial backlighting compensation setting (upon power on)
Setting : ON, OFF, LAST
*
1
(perform backlighting compensation when on)
Init AE Shift 0 Initial exposure compensation of Color Camera video (upon power on)
*
2
Setting :0, +1, +2, LAST
*
1
, -2, -1
Flip OFF Color Camera image top/bottom ip enable/disable
Setting : OFF (Top/bottom ip disabled)
ON (Top/bottom ip enabled)
AutoZoom
Magnication
×10 Magnication of auto zoom
Setting : ×10, ×15, ×22, ×1, ×2, ×3, ×4, ×5, ×7
AutoZoom Time 3 s Auto zoom magnication retention time (seconds)
Setting : 3 s, 5 s, 8 s
AutoZoom End Position ×1 Target magnication of auto zoom
Setting: ×1, ×2, ×3, …, ×22, LAST
*
1
Init Camera1 Rec
LED
ON Initial Color Camera [REC] lamp enable/disable setting (upon power
on)
Setting :
ON ( [REC] lamp lights during recording )
LAST
*
1
OFF ( [REC] lamp does not light )
Init IR Mode AUTO IR switching function
Setting :
AUTO (Automatically switch IR function on/off),
OFF (Force IR function off)
ON (Force IR function on)
LAST
*
1
IR Level LOW IR auto switching level setting
*
3
Setting : LOW, HIGH
IR Time 30 s IR auto switching level detection time (seconds)
*
3
Setting : 30 s, 60 s, 300 s, 10 s
Auto Focus PRESET Select color camera focusing method when,
• [Init LPR Mode] is set to “DISABLE”
• [Init LPR Mode] is set to “ENABLE” and [LPR Mode] is set to
“PATROL”
• A recording trigger starts recording when [Init LPR Mode] is set to
“ENABLE” and [LPR Mode] is set to “LPR”.
Setting :
PRESET (When the zoom is 3x or below, the camera is
focused at a distance of about 15 m (50 feet).
Subsequent zooming will engage auto focus.)
DISABLE (Focus is locked at a distance of about 40 m (130
feet) and auto focus is disabled.)
AUTO (Set to auto focus when zoom ratio has been
changed.)
Init LPR Mode DISABLE LPR (License Plate Recognition) function switching
Setting :
DISABLE (LPR function is off and [LPR Mode] switches to
“PATROL”.)
ENABLE (LPR function is on.)
*
1 Applies the setting in effect when power was last turned
off. Unless power is turned off properly, the operating
state may not be saved correctly.
*
2 When the [Init AE Shift] setting is “+2” and the target is
dark, the image may not refresh at 30 frames/sec.
*
3 The [IR Level] and [IR Time] settings apply only when the
[Init IR Mode] setting is “AUTO”.
(Continued on the next page)