Administrator Setup
(continued)
Service Log
Use this function to copy service log (see “Service Log” on
page 119) to an USB memory device.
1. Connect a USB memory device to this recorder.
2. Select [Service] – [Operations] – [Service Log],
and press the [ ] button to confirm the entry.
A confirmation dialog box appears.
3. Select [OK], and press the [ ] button to
confirm the entry.
A service log is created with the filename of SVddhhmm.
log (dd: day, hh: hours, mm: minutes), and copied to the
top folder of the USB memory device.
Select [Cancel] to stop copying.
Clear Officer Information
Use this function to delete officer data from a recorder.
1. Select [Service] – [Operations] – [Clear Officer
Information], and press the [ ] button to
confirm the entry.
A confirmation dialog box appears.
2. Select [OK], and press the [ ] button to
confirm the entry.
Officer data will be deleted.
Select [Cancel] to stop deleting officer data.
Factory Default
All recorder settings can be returned to their factory defaults.
The following settings do not return to their factory defaults.
• Recorder Operating Time
• FAN Operating Time
• CAM1 Operating Time
• Remote Control Panel Operating Time
• LCD Lighting Time
• Recorder Version
• Recorder serial number
• Microcontroller Version
• Remote Control Panel Version
Note that the recorder will not revert to user made settings
after being reset to their factory defaults. Make sure you
really want to return all settings to their factory defaults
before performing the following steps.
1. Select [Service] - [Operations] - [Factory
Default], and press the [ ] button to confirm
the entry.
A confirmation dialog box appears.
2. Select [OK], and accept by pressing the [ ]
button.
The recorder will reboot and start up in the factory default
settings.
Select [Cancel] to cancel returning to the factory defaults.
To Next Page
Loading...
