- 83 -
≥ Area Function is not possible in following cases:
j In Variable Frame Rate Mode (l 91)
j When a remote control (commercially-available) is connected (l 113 )
≥ Area mode is canceled in following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j When you set [REC FORMAT] to [4K 2160/24.00p 100M] (l 142)
j When you set [OUTPUT FORMAT] to [4K 2160/24.00p] (l 147)
j When the setting of [ASPECT CONVERT] is changed (l 148)
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 122)
≥ When using Area Mode, even if you set [ZEBRA] to [MARKER], the luminance display frame will
not be displayed. (l 88, 155)
In addition, the luminance level will not be displayed if [AREA MODE] is set to [FOCUS], [IRIS] or
[FOCUS/IRIS].
≥ Register “Focus Transition” to a USER button. (l 74)
≥ Switch to Manual Focus Mode. (l 44)
With Focus Transition, you can move the current focus position to a pre-registered focus position.
(l 52)
≥ Register “Capture” to a USER button. (l 74)
You can record still pictures or create still pictures from recorded motion pictures. (l 34, 106)
≥ Register “EVF/LCD detail” to a USER button. (l 74)
[EVF/LCD DETAIL] helps you achieve focus easier by emphasizing the outlines of an image
displayed on the LCD monitor or the viewfinder. (l 45)
≥ These settings will not affect the images actually recorded.
Focus Transition
Capture
EVF/LCD detail
To Next Page