Panasonic AW-HS50E - Page 36

35 (E)
2. Input/output signal settings
[11] Output Menu
6. DVI-OUT:Scale
This is used to select one of the scaling methods listed
below.
Fit-V The aspect ratio of the output image is
maintained, and the size of the image is
enlarged or reduced in accordance with the
vertical resolution.
 Black images are inserted into areas where
there are no images.
 Parts of images that protrude are cropped.
Fit-H The aspect ratio of the output image is
maintained, and the size of the image is
enlarged or reduced in accordance with the
horizontal resolution.
 Black images are inserted into areas where
there are no images.
 Parts of images that protrude are cropped.
FULL The size of the output image is enlarged
or reduced in accordance with the system
resolution.
 The aspect ratio of the image is not
maintained.
 The enlargement and reduction ratios
differ between the horizontal and vertical
directions.
[11] Output Menu
7. DVI-OUT:Mvdet
This is used to set the sensitivity with which the motion of
moving images is to be detected.
12345
Toward still images Standard Toward moving images