Panasonic DP-8032 - Page 149

149
DP-8032/8025
2008Ver. 1.2
J07 The Registration Sensor does not detect paper within a predetermined time after the
paper starts feeding from 2nd Feeder Unit. (2/3/4 Feeder Unit)
C, D2
J08 The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating on the 3rd Feeder Unit. (3/4 Feeder Unit)
D3
J09 The Registration Sensor did not detect paper within a predetermined time after the
Paper Feed Roller started rotating on the 4th Feeder Unit. (4th Feeder Unit)
D4
J12 The 2nd Registration Sensor does not go off within a predetermined time after the
Paper Path Sensor is activated.
C, D2
J13 The 3rd Registration Sensor does not go off within a predetermined time after the
Paper Path Sensor is activated.
D3
J14 The 4th Registration Sensor does not go off within a predetermined time after the
Paper Path Sensor is activated.
D4
J19 The Registration Sensor does not detect within a predetermined time after the
Automatic Duplex Unit Sensor 4 is activated.
C
J22 The 2nd Registration Sensor detect paper at the time of the initials. C, D2
J23 The 3rd Registration Sensor detect paper at the time of the initials. D2, D3
J24 The 4th Registration Sensor detect paper at the time of the initials. D3, D4
J30 The Registration Sensor does not go off within a predetermined time after the Sensor
is activated. (Sheet Bypass)
C
J31 The Registration Sensor does not go off within a predetermined time after the Sensor
is activated. (Except Sheet Bypass)
C
J32 The Registration Sensor does not go off within a predetermined time after the Sensor
is activated. (i-ADF)
C
J33 The Registration Sensor detects paper during non-printing mode. C
J40 The Fuser Unit Paper Exit Sensor does not detect paper within a predetermined time
after the Registration Sensor is activated.
C
J41 The Fuser Unit Paper Exit Sensor does not go off within a predetermined time after
the Sensor is activated.
C
J42 The Fuser Unit Paper Exit Sensor detects paper during non-printing mode. C
J43 The Exit Sensor does not detect paper within a predetermined time after the Fuser
Unit Paper Exit Sensor is activated.
C
J44 The Paper Exit Sensor keeps detecting paper after a predetermined time. C
J45 The Paper Exit Sensor keeps detecting paper after a predetermined time, during
non-printing mode.
C
J46 The Dual-Path Exit Sensor does not go off within a predetermined time after the
Sensor is activated.
C
J47 The Dual-Path Exit Sensor keeps detecting paper after a predetermined time, during
non-printing mode.
C
J48 The Dual-Path Exit Sensor does not detect paper within a predetermined time after
the Fuser Unit Paper Exit Sensor is activated.
C
J51 The Paper Transport Unit Sensor 2 does not detect paper within a predetermined
time after eject paper Sensor of dual-path exit guide unit is activated.
B, C
J53 The Paper Transport Unit Sensor 4 does not detect paper within a predetermined
time after eject paper Sensor of dual-path exit guide unit is activated.
B, C
J56 The Paper Transport Unit Sensor 2 does not go off within a predetermined time. B, C
J58 The Paper Transport Unit Sensor 4 does not go off within a predetermined time. B, C
J59 The Paper Transport Unit Sensor detects paper during non-printing mode. B
J60 The Finisher Registration Sensor is not detects paper within a predetermined time
after the Paper Transport Unit Sensor is activated.
A
J61 The stapler is not activated correctly. A
Jam Error Codes (J Code) Table
Code Contents Section