Panasonic DP-8032 - Page 298

298
DP-8032/8025
2008Ver.1.2
(27) Release the pre-installed Harness from the Harness
Clamp.
(28) Install the Optional LVPS.
(29) Secure the Optional LVPS with 4 Screws
(XTW3+6LFC).
(30) Connect the LVS2 Harness to CN64 on the Optional
LVPS and to CN102 on ACD PC Board.
(31) Secure the LVS2 Harness with the Harness Clamp.
(32) Connect the pre-installed Harness to CN65 and
CN66 on the Optional LVPS.
(33) Close the LVPS Cover.
(34) Reinstall the Left Cover.
(35) Hook the Base Bracket and secure with 2 Silver
Thumb Screws (PF4124P023).
Note:
a. Ensure that the Mylar Sheet on the Base Bracket
does not get damaged.
b. It is easier to align the screw holes, if you insert the
Front Screw first.