326
DP-8032/8025
2008Ver.1.2
(29) Remove 2 Screws.
(30) Remove the HP Cover.
(31) Connect the HT2 Harness to the RLB PC Board
(CN174).
(32) Reinstall the HP Cover.
(33) Connect the HT5 Harness to the HT2 Harness.
(34) Insert the HT5 Harness to the Harness Clamp.
(35) Connect the CST2 Harness to SPC PC Board
(CN707).
(36) Reinstall the all Covers.
<For 3-Paper Tray Configuration>
(1) Open the Right Cover.
(2) Remove 2 Silver Screws.
(3) Remove the Right Rear Cover.
(4) Remove 6 Silver Screws.
(5) Remove 3 Lower Rear Covers.
Caution:
The OPC Drum is sensitive to light. To prevent optical
exposure problems, do not expose the OPC Drum to
direct sunlight or bright light (even if it is a 1000-Lux
fluorescent lamp).
To Next Page
Loading...
