57
DP-8032/8025
2008Ver. 1.2
(15) Remove the Harness from clamp, disconnect the
Connector.
(16) Remove 2 Screws (51) and 1 Snap Ring (G6).
(17) Remove the Hopper Unit.
Note:
When reinstalling the Hopper Unit, insert the hooks
into the recessed holes on the Developer Unit as
illustrated.
(18) Release 3 Latch Hooks and remove the Developer
Cover (825).
<Removing the Old Developer and Toner>
(19) Stand the Developer Unit as illustrated over a suitable
container and dump the used Developer and Toner by
rotating the Gear.
(20) Clean the Developer Unit with a dry soft cloth.
(21) Reinstall the Hopper Unit.
To Next Page
Loading...
