18
Chapter 2 Basic Fax Transmission
Fax Transmission Procedure
You can send originals via a telephone line by simply entering the fax number using the Keypad or the
Address Book.
The basic procedure of transmitting a fax on this machine is as follows.
z The Facsimile function is available only when the optional G3 Fax Communication Board is installed.
1
Place original(s).
z Refer to Placing Originals (see page 14).
z If the available memory is not sufficient,
Memory transmission may not be possible.
If this happens, use Direct transmission
instead. Refer to Direct Transmission (see
page 48).
2
Press the Fax key to open the Fax
screen.
Select āBasic Menuā if additional
settings are required.
z Setting Original Quality (see page 34)
z Setting the Original Size (see page 38)
z Transmitting 2-Sided Originals (see page
40)
z Job Build and SADF (see page 46)
z Verification Stamp (see page 42)
z Transmitting a Document Stored in
Memory (see page 44)
z Direct Transmission (see page 48)
z Verifying Communication Status (see
page 50)
Face up. Up to 100 sheets
(20 lb/Letter)
Face down. Align with the top
left corner. Close ADF.
Used memory
To Next Page
Loading...
