46
Chapter 2 Basic Fax Transmission
Job Build and SADF
The Job Build and SADF setting enables to scan sets of originals that exceed the maximum capacity of
ADF. Special originals (thin paper, etc.) can be fed from the ADF for Memory transmission.
This function is available when “Job Build and SADF” is selected in the “Basic Menu”.
z The standard setting of “133 Job Build and SADF Mode” is set to “No”. For instructions on how to change the
standard setting, refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) of
provided CD-ROM.
z This function is available when the Function Parameter “05 Memory (HOME)” (Fax/Email Settings > Fax
Parameters) is set to “On”.
z The Function Parameter “82 Quick Memory XMT” (Fax/Email Settings > Fax Parameters) is not available for
this function.
z Up to 255 pages can be stored. When the number of pages exceeds 255, the memory overfull message will be
displayed. Select “Yes” to start transmitting, or “No” to cancel.
If no action is taken within 5 seconds, the machine will start transmitting the stored originals.
1
Place original(s).
z Refer to Placing Originals (see page 14).
2
Press the Fax key.
3
Select “Basic Menu”.
4
Select “Job Build and SADF”.
5
Set “Quality Adj.” as required.
z Refer to Setting Original Quality (see page
34).
Face up. Up to 100 sheets
(20 lb/Letter)
To Next Page
Loading...
