42
Chapter 2 Basic Fax Transmission
Verification Stamp
This function confirms successful transmission or storage
into the memory by stamping at the bottom of each
successfully transmitted original(s) with a small “x” mark.
z
The scanned document(s) are stamped after feeding through the ADF.
z
The standard setting of the Verification Stamp is “
Off
”. The stamp setting can be changed with the Function Parameter
“
04 Stamp (HOME)
” (Fax/Email Settings > Fax Parameters). For instructions on how to change the standard setting,
refer to
Fax/Email Settings
in the Operating Instructions (For Function Parameters) of provided CD-ROM.
z The machine can be configured not to stamp the documents stored in the memory by changing the setting of
the Function Parameter
“28 Stamp at Memory XMT” (Fax/Email Settings > Fax Parameters). For instructions
on how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (For
Function Parameters) of provided CD-ROM.
z The Verification Stamp function is available when scanning documents with the ADF.
z Because the verification stamp cannot be deleted, be careful not to use the verification stamp when
transmitting important document(s).
1
Place original(s) on the ADF.
z Refer to Placing Originals (see page 14).
2
Press the Fax key.
3
Select “Basic Menu”.
4
Select “Verification Stamp”.
5
Set “Quality Adj.” as required.
z Refer to Setting Original Quality (see page
34).
6
Select “Address Book”, and then
select a destination.
z Refer to Entering a Destination (see page
20).
7
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
z The setting of the “Verification Stamp” is
returned to Off after the transmission is
completed.
Verification Stamp
Ex: Scanning
Direction
To Next Page
Loading...
