22
Chapter 2 Basic Fax Transmission
Using the Address Book
Use a Key Name
If a destination is registered in the Address
Book, it can be selected by using a Key Name.
z The fax numbers must be pre-programmed into
the Address Book. Refer to Adding a Fax Number
into the Address Book (see page 177).
1
Follow the step 1 and 2 on page 18.
2
Select the Key Name tab.
3
Select the desired destination.
z To cancel a choice, select the same
destination again.
z To enter additional destinations, repeat
steps 2 and 3.
z To confirm the destinations, select
“Destinations: ###” on the upper left corner
of the screen.
4
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
Select from “Favorites”
If a destination is registered as a Favorite in the
Address Book, it can be selected using the
“Favorites” tab.
z The fax numbers must be pre-programmed into
the Address Book. Refer to Adding a Fax Number
into the Address Book (see page 177).
1
Follow the step 1 and 2 on page 18.
2
Select “Favorites” to display the
Favorites screen.
3
Select the desired destination.
z To cancel a choice, select the same
destination again.
z For transmission to additional destinations,
press the relevant keys.
z To confirm the destinations, select
“Destinations: ###” on the upper left corner
of the screen.
4
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
To Next Page
Loading...
