Panasonic HEVC Advance AW-UE160WP - MoIP and ST2110 Transmission Status

Subnet(IPv4)
Enter the subnet mask.
Factory settings: 255.255.255.255
<NOTE>
• [Address(IPv4)] and [Subnet(IPv4)] clarify the multicast address
ranges randomly selected during multicast transmissions.
• When [Address(IPv4)] is set to [239.255.0.0] and [Subnet(IPv4)] is
set to [255.255.0.0], the selection is made randomly in the range
between [239.255.0.0] and [239.255.255.255].
• To use the IP address set in [Address(IPv4)], set [Subnet(IPv4)] to
[255.255.255.255].
TTL/HOP Limit
The same as [H.264] [Multicast TTL/HOPLimit] (→ page 129).
Group [Enable, Disable]
Sets whether to use the grouping function when performing NDI
transmission.
Factory settings: Disable
Name
Sets the group name for use when grouping function is used.
Use discovery server
Sets whether to use the discovery server when performing NDI
transmission.
Server address(IPv4)
Sets the IPv4 address of the server when using the discovery
server.

MoIP settings screen [Media over IP]
Make settings related to MoIP (SMPTE ST2110/NMOS/PTP).
<NOTE>
• To use this function with AW-UE160, the SMPTE ST2110 software key
(AW-SFU60) needs to be enabled.
z Setting status
ST2110
Display the Off/On status of the SMPTE ST2110 function and the port
number used for SMPTE ST2110 transmissions.
Main video TX
Display the transmission settings for [Main video TX].
Crop video TX
Display the transmission settings for [Crop video TX].
Monitor video TX
Display the transmission settings for [Monitor video TX].
Input1 audio TX
Display the transmission settings for [Input1 audio TX].
Input2 audio TX
Display the transmission settings for [Input2 audio TX].
Return video RX
Display the transmission settings for [Return video RX].
PTP
Display the [PTP] settings.
NMOS
Display the [NMOS] settings.
NMOS Master Enable
Display the [NMOS Master Enable] settings.
This setting can be switched from an NMOS controller that is on the
same network as the camera. It is a setting to enable/disable SMPTE
ST2110 transmitting and receiving.
<NOTE>
• The camera starts with this setting [On] when it is started. The
setting value cannot be saved.
135
Web screen configurations (continued)