z ST2110 TX
Make SMPTE ST2110 transmission settings.
The setting is confirmed with the [Set] button.
<NOTE>
• This menu is not displayed when [ST2110] is [Off].
Main video
<NOTE>
• Camera images without overlays such as OSD menus and CROP
frames are output from Main video.
• When [ST2110] is [Off], Main video is not output.
Format
Set the output format for [Main video].
Frequency
System Format Format(ST2110)
59.94Hz 1080/59.94p 1080/59.94p
1080/59.94i
50Hz 1080/50p 1080/50p
1080/50i
For formats other than the above, there is display only and the
settings cannot be changed.
Destination Address
Enter the IP address of the transmission destination for [Main video].
IP addresses can be set in the following ranges:
First octet 0 to 239
Second octet 0 to 255
Third octet 0 to 255
Fourth octet 0 to 255
You cannot set 0.0.0.0, 224.0.0.0 to 224.0.1.255, or a 127 IP address
for the first octet.
Factory settings: 239.1.0.1
Destination Port [1024 to 65535]
Enter the [Main video] transmission destination port number.
10670 cannot be set as a port number.
Factory settings: 49311
z ST2110
SMPTE ST2110 can be transmitted and received from SFP+ with this
unit.
The setting is confirmed with the [Set] button.
<NOTE>
• This item cannot be set if the SMPTE ST2110 software key
(AW-SFU60) is disabled.
• This cannot be set when the [Basic Config] – [SFP+ Mode] is [12G
Output].
ST2110 [On, Off]
Set On/Off for SMPTE ST2110 transmitting and receiving.
Factory settings: Off
ST2110 port [1024 to 65535]
Enter the port number for SMPTE ST2110 (used when transmitting
SMPTE ST2110 from this unit).
10670 cannot be set as a port number.
Factory settings: 49330
136
Web screen configurations (continued)
To Next Page
Loading...
