Audio setting screen [Audio]
Configure audio settings.
<NOTE>
• Images and audio are not synchronized. Therefore, images and audio
may be slightly out of sync.
• The audio may skip depending on the network environment.
z Setting status
Audio
The setting status of audio input is displayed.
Input1 Setting
Display the setting status of audio input 1.
Input2 Setting
Display the setting status of audio input 2.
Output Setting
Display the setting status of audio output.
Audio over IP
Audio
transmission
The setting status of audio data IP transmission is
displayed.
Audio bit rate The bit rate setting status for audio data via IP
transmission is displayed.
Audio over ST2110
Display the setting status of audio data with SMPTE ST2110
transmission.
z Audio
The setting is confirmed with the [Set] button.
Audio [Off, On]
Turn audio input Off/On.
Factory settings: Off
Input Setting 1
Input Select [LINE, MIC, MIC+48V]
Set the input switching for Audio Input1.
LINE Sets to line input.
MIC Sets to microphone input.
MIC+48V Sets to phantom power supply +48V microphone input.
This is only enabled when [Audio] is set to [On].
Factory settings: LINE
Mic Gain [60dB, 40dB]
Set the microphone amplifier GAIN for the Audio Input1 microphone
input.
This is enabled only when [Audio]
– [Input1 Setting] – [Input Select] is
[MIC] or [MIC+48V].
Factory settings: 60dB
Line Level [+4dB, 0dB]
Set the input level for the Audio Input1 line input.
This is enabled only when [Audio]
– [Input1 Setting] – [Input Select] is
[LINE].
Factory settings: 0dB
140
Web screen configurations (continued)
To Next Page
Loading...
