OUTPUT ITEM [MENU ONLY, STATUS]
Select the type of OSD to be superimposed on output video.
MENU ONLY Displays the OSD menu only.
STATUS Displays the OSD menu and OSD status.
CHAR [OFF, ON]
Set whether to superimpose the OSD.
3G SDI [LEVEL-A, LEVEL-B]
When [FORMAT SELECT] (3G SDI OUT1) is [1080/59.94p],
[1080/60p] or [1080/50p], select the format for outputting 3G SDI
signals.
<NOTE>
• [3G SDI] cannot be changed if [FORMAT SELECT] (3G SDI OUT1)
is other than [1080/59.94p], [1080/60p] or [1080/50p].
3G SDI OUT2/PM
Make the settings for output from the 3G SDI OUT2/PM connector.
OUTPUT SELECT [CAM, RETURN]
Switch between outputting the camera images and the images
received through RETURN (images input through SMPTE ST2110).
CAM Outputs camera input images.
RETURN Outputs images received through RETURN (SMPTE
ST2110 input images).
<NOTE>
• This cannot be set when [BASIC CONFIG] – [FORMAT] is other
than [1080/59.94p] or [1080/50p].
• This cannot be set when the [BASIC CONFIG] – [SFP+ MODE] is
[12G OUTPUT].
• This cannot be set when [CROP] – [UHD CROP] is [CROP(1080)]
or [CROP(720)].
• This item cannot be set if the SMPTE ST2110 software key
(AW-SFU60) is disabled.
FORMAT SELECT
Set the output format.
The following formats can be set depending on the settings in
[FORMAT] in [BASIC CONFIG].
Frequency
System Format
Format
(3G SDI OUT2/PM)
60Hz 2160/60p 1080/60p
1080/60p 1080/60p
59.94Hz 2160/59.94p 1080/59.94p
*
1
1080/59.94i
*
1
2160/29.97p 1080/29.97p
1080/119.88p 1080/59.94p
*
3
1080/59.94p 1080/59.94p
1080/59.94i
1080/29.97p 1080/29.97p
720/59.94p 720/59.94p
50Hz 2160/50p 1080/50p
*
2
1080/50i
*
2
2160/25p 1080/25p
1080/100p 1080/50p
*
3
1080/50p 1080/50p
1080/50i
1080/25p 1080/25p
720/50p 720/50p
24Hz 2160/24p 1080/24p
1080/24p 1080/24p
23.98Hz 2160/23.98p 1080/23.98p
1080/23.98p 1080/23.98p
*
1
When [UHD CROP] is [CROP(720)], output is 720/59.94p.
*
2
When [UHD CROP] is [CROP(720)], output is 720/50p.
*
3
For 119.88p (or 100p), “Frame 2” is output with the frame rate cut
to half (59.94p (or 50p)).
<NOTE>
• When [3G SDI OUT2/PM] – [OUTPUT SELECT] is [RETURN],
the format displayed is the same as [IP SIGNAL] – [ST2110] –
[RET VIDEO RX] and cannot be changed.
54
Camera menu items (continued)
To Next Page
Loading...
