7.5 Replacing Limited Life Parts
TOP PREVIOUS NEXT
If Warning Replace Roller message is displayed on the LCD, replace the Paper Feed Roller Module and Retard Roller Module at the same time.
1. Turn the power off and unplug the power cord.
2. Use your fingers to hold down the Front Door Release. Then open the Front Door completely.
3. Place your finger on the Paper Feed Roller Block Shaft and pull it towards you to remove the Paper Feed Roller Block from the magnet
[(1)]. Push down the Green Lock Levers and remove the Paper Feed Roller Module from the scanner by holding theGreen Lock Levers
[(2)].
Note:
The Paper Feed Roller Block is attached by magnetic power. When moving the Green Lock Lever, do not apply pressure in any other
direction than the arrows. Otherwise, they may break.
To Next Page
Loading...
